 
|
|||||||||||||||||||||||||||||||||||||
Polyslick® UHMW Rod exhibits all of the durable qualities of our Polyslick® UHMW Sheet making it perfect for the application where sheet stock is not suitable. The material is ideally suited for the manufacture of bushings, bearings, rollers, and augers as there is much less wasted material than if the material was made out of sheet stock. Polyslick® UHMW Rod is available in up to 10 inches in diameter and is available out of stock in natural virgin and black reprocessed grades.
| Moisture resistant Chemical resistant Stress crack resistant Low coefficient of friction Prevents steel degradation Non toxic / Non hazardous Pultruded rod available for tight tolerances and dimensional stability |
Easy to clean Easily machined High impact strength High energy absorption High abrasion resistance Reduces machine noise |
 |
|
| Smooth as extruded | |
| Note: Charge marks may be visible on surface | |
| Gears Spools Wear Strips Machine Parts Bottling Equipment |
Augers Nozzles Wear Guides Shaft Sleeves Conveyor Parts |
Rollers Bearings Bushings Sprockets Change Parts |
 |
||
| *Natural | Black | |
| *FDA and USDA approved color. RoHs and REACH Compliant. | ||
| Ram Extruded inch/mm |
Pultruded inch/mm |
||
| Diameter | 0.25 - 10 / 6 - 250 | 0.5 - 2 / 12.7 - 50 Selective Sizes |
|
| Length | 120 / 3050 | 17 or 60 / 425 or 1525 |